Quick answer

Replacing the Shark HV382 drive belt is a DIY job of about 10 minutes. Compatible drive belts currently start at $4.97. Replace it Every 12 months under normal use. Full step-by-step below.

Compatible Drive Belt for the Shark HV382

Prices pulled from Amazon and verified September 2026. “OEM” is a genuine Shark part; the rest are tested aftermarket options.

PartTypePriceRating
3PCS Soft Front Brush Belt Replacement Part 153-3GT-8 for Shark AZ1002 AZ1000 AX950 AX951 ZU782 Vacuum Aftermarket $7.99 4.65★ (799) Buy on Amazon
Replacement Belt for Shark HV300 Vacuum Cleaner,Compatible with Models: HV301, HV302, HV305, HV308 Series(2 Belt Aftermarket $6.99 4.65★ (454) Buy on Amazon
Replacement Vacuum Belts for Shark Rotator: 3M-231-6 Gear Drive Belts for Shark Professional and Power Lift-Away Vacuum Cleaner NV500 NV501 NV502 NV503 NV505 NV500W NV400 NV752 440001893 (Pack of 2) Aftermarket $12.99
$6.50/ea
4.55★ (385) Buy on Amazon
Vacuum Belt Compatible with Shark Vacuum Cleaner Models NV350, NV351, NV352, NV353, NV355, NV356, NV357, NV360, NV22, NV42, NV44, NV46, UV400, UV410, UV420, UV440 Lift-Away Aftermarket $4.97
$2.48/ea
4.65★ (314) Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

Step-by-Step: Replacing the Shark HV382 Drive Belt

1
Unplug the vacuum
Always disconnect power before any internal work on your Shark HV382.
2
Open the base plate
Remove any screws securing the base plate and set aside.
3
Remove the brush roll
Lift out the brush roll to expose the belt underneath.
4
Remove the old belt
Slide the worn belt off the motor spindle and brush roll hub.
5
Install the new belt
Loop the new belt around the motor shaft first, then stretch over the brush roll hub.
6
Reassemble and test
Replace brush roll and base plate. Test that the brush roll spins freely.

⚠ Common mistakes to avoid

  • Confirm the part matches your exact model number before buying — Shark reuses parts across lines.
  • Never wash a filter unless it's marked washable, and dry it fully (24h) before refitting.
  • Don't force the part — if it resists, check alignment before applying pressure.
  • Always disconnect power (or remove the battery) before any internal work.
🔁 How often to replace

The Shark HV382 drive belt should be replaced Every 12 months under normal use — sooner with pets or daily heavy use. Signs it's due: Brush roll not spinning.

How we made this page: the steps are written for the Shark HV382 specifically; the compatible-part list is pulled from our parts database and price-checked against Amazon. Last verified September 2026.