Quick answer

Replacing the Shark HV382 brush roll is a DIY job of about 10 minutes. Replace it Every 12-24 months under normal use. Full step-by-step below.

The HV382 brush roll is held in the cleaner head by an end cap or cover. Wound hair around the bar and its end bearings is the usual reason it stops spinning or the head whines — often a cleanout, but a worn bar should be swapped.

Compatible Brush Roll for the Shark HV382

“OEM” is a genuine Shark part; the rest are tested aftermarket options.

PartType
First4Spares Vacuum Cleaner Brushroll Brushbar for Shark Navigator NV356E & NV42 Deluxe Aftermarket Buy on Amazon
WD161 Roller and Filter For Shark HydroVac MessMaster Wet Dry Vacuum Cleaner WD161 WD261 AW261 (3 Brush 6 Foam Filter Kit) Aftermarket Buy on Amazon
HZ3002 Replacement Brush Roller and Filters for Shark HZ3002/ HZ3000 Vacuum Cleaner - Replace Parts XFFKHZ3000 XHFHZ3000, 1 Brush Roller 2 HEPA Filters & 2 Foam and Felt Filters Aftermarket Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

About the Shark HV382

The Shark Rocket HV382 is a lightweight corded stick with a single brush roll in the cleaner head. The brush roll agitates carpet and sweeps hard floors; flattened bristles and wrapped hair are what most owners replace.

Step-by-Step: Replacing the Shark HV382 Brush Roll

1
Power off and unplug
Switch off and unplug the HV382 before working on the head.
2
Open the brush-roll cover
Release the cover/end cap on the underside of the cleaner head.
3
Remove and clear
Lift the roll out and cut away all wound hair from the bar and the housing channel.
4
Fit the new roll
Seat the new bar into its drive and end seats.
5
Close and test
Refit the cover, plug in and confirm the roll spins.

⚠ Common mistakes on the HV382

The HV382 mistake is replacing the roll when it just needs the wound hair cut from the bar and end caps. The second is forcing the cover instead of releasing it correctly.

✓ OEM vs aftermarket for the HV382

A genuine Shark roll guarantees the right bristles and fit; aftermarket bars are cheaper and fine when the listing names HV382 (and the HV300 Rocket family). Clear the housing before fitting a new bar so it runs true.

🔁 How often to replace

The Shark HV382 brush roll should be replaced Every 12-24 months under normal use — sooner with pets or daily heavy use. Signs it's due: Poor carpet pick-up, visible wear.

How we made this page: the steps are written for the Shark HV382 specifically; the compatible-part list comes from our own compatibility data for this model. We are not showing prices at the moment — check the current price on Amazon.