How to Replace Hoover WindTunnel T-Series UH30310 HEPA Filter (Step-by-Step Guide)

⏱ ~10 minutes 🔧 No special tools 🔁 Every 12 months Verified October 2026
Quick answer

Replacing the Hoover WindTunnel T-Series UH30310 hepa filter is a DIY job of about 10 minutes. Replace it Every 12 months under normal use. Full step-by-step below.

Compatible HEPA Filter for the Hoover WindTunnel T-Series UH30310

“OEM” is a genuine Hoover part; the rest are tested aftermarket options.

PartType
Genuine Hoover Filter Kit to fit Hoover T-Series WindTunnel Bagless Upright- Includes Washable 303173001, and HEPA Cartridge 303172002 OEM Buy on Amazon
Genuine Hoover T-Series Exhaust HEPA Filter OEM Buy on Amazon
Hoover WindTunnel Y HEPA Pleated Vacuum Filter Bags 2 pack AH10040 902419001 OEM Buy on Amazon
EnviroCare Replacement HEPA Filtration Vacuum Cleaner Filters made to fit Hoover Self-Propelled WindTunnel 2 filters Aftermarket Buy on Amazon
Replacement Compatible for Hoover T-Series WindTunnel Bagless Upright Filter Kit - Includes Washable Filter Compare to Part 303173001, and HEPA Cartridge Filter Compare to Part 303172002 Aftermarket Buy on Amazon
Replacement Part For Hoover WindTunnel T-Series Vacuum Cleaner Inlet Secondary Filter (4 Filters) Fits Models UH30310, UH30300, UH30600, UH30302, CH53005. # compare to part 902417001 Aftermarket Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

Step-by-Step: Replacing the Hoover WindTunnel T-Series UH30310 HEPA Filter

1
Power off and unplug
Turn off your Hoover WindTunnel T-Series UH30310 and unplug it from the wall. If cordless, remove the battery pack.
2
Locate the filter compartment
Find the hepa filter housing — on most WindTunnel T-Series UH30310 units it's located near the top or rear of the cyclone assembly.
3
Remove the old filter
Twist or slide out the existing hepa filter. Avoid tapping it — this releases trapped particles into the air.
4
Inspect and clean housing
Wipe the filter housing with a dry cloth. Do not use water or cleaning products inside the vacuum.
5
Insert the new filter
Align the new hepa filter with the housing guides and press firmly until it clicks into place.
6
Test suction
Plug in (or reinsert battery) and run briefly to confirm normal suction is restored.

⚠ Common mistakes to avoid

  • Confirm the part matches your exact model number before buying — Hoover reuses parts across lines.
  • Never wash a filter unless it's marked washable, and dry it fully (24h) before refitting.
  • Don't force the part — if it resists, check alignment before applying pressure.
  • Always disconnect power (or remove the battery) before any internal work.
🔁 How often to replace

The Hoover WindTunnel T-Series UH30310 hepa filter should be replaced Every 12 months under normal use — sooner with pets or daily heavy use. Signs it's due: Reduced suction, musty odor.

How we made this page: the steps describe the standard procedure for this part type; we have not yet written a model-specific version for the Hoover WindTunnel T-Series UH30310; the compatible-part list comes from our own compatibility data for this model. We are not showing prices at the moment — check the current price on Amazon.