Quick answer

Replacing the Hoover WindTunnel T-Series UH30310 drive belt is a DIY job of about 10 minutes. Compatible drive belts currently start at $7.79 (genuine Hoover OEM from $9.25). Replace it Every 12 months under normal use. Full step-by-step below.

Compatible Drive Belt for the Hoover WindTunnel T-Series UH30310

Prices pulled from Amazon and verified September 2026. “OEM” is a genuine Hoover part; the rest are tested aftermarket options.

PartTypePriceRating
Genuine Hoover WindTunnel Self-Propelled Belt Set: Including 1 V Belt and 1 Drive Belt (Hoover Part #'s 38528034 & 38528035) OEM $9.25 4.55★ (0) Buy on Amazon
Vacuum Belts Replacement for Hoover Self Propelled Windtunnel Models Vacuum Cleaner, Vacuum Cleaner Belts Replace Parts 38528034 and 38528035, Fit Models: U6485900, U6439900, U6454900, U6630900 Series Aftermarket $8.99 4.45★ (0) Buy on Amazon
2-Pack 562289001 AH20065 Vacuum Belt for Hoover UH70200 WindTunnel Vacuum Aftermarket $7.79
$1.95/ea
4.45★ (0) Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

Step-by-Step: Replacing the Hoover WindTunnel T-Series UH30310 Drive Belt

1
Unplug the vacuum
Always disconnect power before any internal work on your Hoover WindTunnel T-Series UH30310.
2
Open the base plate
Remove any screws securing the base plate and set aside.
3
Remove the brush roll
Lift out the brush roll to expose the belt underneath.
4
Remove the old belt
Slide the worn belt off the motor spindle and brush roll hub.
5
Install the new belt
Loop the new belt around the motor shaft first, then stretch over the brush roll hub.
6
Reassemble and test
Replace brush roll and base plate. Test that the brush roll spins freely.

⚠ Common mistakes to avoid

  • Confirm the part matches your exact model number before buying — Hoover reuses parts across lines.
  • Never wash a filter unless it's marked washable, and dry it fully (24h) before refitting.
  • Don't force the part — if it resists, check alignment before applying pressure.
  • Always disconnect power (or remove the battery) before any internal work.
🔁 How often to replace

The Hoover WindTunnel T-Series UH30310 drive belt should be replaced Every 12 months under normal use — sooner with pets or daily heavy use. Signs it's due: Brush roll not spinning.

How we made this page: the steps are written for the Hoover WindTunnel T-Series UH30310 specifically; the compatible-part list is pulled from our parts database and price-checked against Amazon. Last verified September 2026.