Replacing the Dyson DC33 HEPA Filter — Step by Step

⏱ ~10 minutes 🔧 No special tools 🔁 Every 12 months Verified October 2026
Quick answer

Replacing the Dyson DC33 hepa filter is a DIY job of about 10 minutes. Replace it Every 12 months under normal use. Full step-by-step below.

Compatible HEPA Filter for the Dyson DC33

“OEM” is a genuine Dyson part; the rest are tested aftermarket options.

PartType
Dyson DC33 Multi-Floor Animal Replacement Exhaust HEPA Filter Assembly For Dyson Part 921616-01, Generic by Dust Care OEM Buy on Amazon
for Dyson DC33 Animal, DC33 All Floor Replacement Bundle Filter Kit, 1 DC33 Washable Dust Cup Primary Filter, 1 DC 33 Post Motor HEPA Exhaust Filter, Generic for 919563-02 921616-01 Aftermarket Buy on Amazon
Casa Vacuums Filter Kit for Dyson DC33 Multi Floor - Total Clean - Exclusive Models. 1 Pre- Filter & 1 HEPA Filter. Compare to 919563-02 & 921616-01 Aftermarket Buy on Amazon
Fette Filter - 3350 Hepa Filter Replacement Compatible with Bissell Crosswave X7 Wet Dry Vac Model Number 3276A 3279 3277 3011 3055 Compare to Part Number 3350 Pack of 4 Aftermarket Buy on Amazon
Compatible For Dyson DC28 DC33 DC37 DC39 DC41 DC53 Vacuum Cleaner Parts Hepa Filter Accessories Replacement(2pcs) Aftermarket Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

Step-by-Step: Replacing the Dyson DC33 HEPA Filter

1
Power off and unplug
Turn off your Dyson DC33 and unplug it from the wall. If cordless, remove the battery pack.
2
Locate the filter compartment
Find the hepa filter housing — on most DC33 units it's located near the top or rear of the cyclone assembly.
3
Remove the old filter
Twist or slide out the existing hepa filter. Avoid tapping it — this releases trapped particles into the air.
4
Inspect and clean housing
Wipe the filter housing with a dry cloth. Do not use water or cleaning products inside the vacuum.
5
Insert the new filter
Align the new hepa filter with the housing guides and press firmly until it clicks into place.
6
Test suction
Plug in (or reinsert battery) and run briefly to confirm normal suction is restored.

⚠ Common mistakes to avoid

  • Confirm the part matches your exact model number before buying — Dyson reuses parts across lines.
  • Never wash a filter unless it's marked washable, and dry it fully (24h) before refitting.
  • Don't force the part — if it resists, check alignment before applying pressure.
  • Always disconnect power (or remove the battery) before any internal work.
🔁 How often to replace

The Dyson DC33 hepa filter should be replaced Every 12 months under normal use — sooner with pets or daily heavy use. Signs it's due: Reduced suction, musty odor.

How we made this page: the steps describe the standard procedure for this part type; we have not yet written a model-specific version for the Dyson DC33; the compatible-part list comes from our own compatibility data for this model. We are not showing prices at the moment — check the current price on Amazon.