Quick answer

Replacing the Dyson DC33 brush roll is a DIY job of about 10 minutes. Replace it Every 12-24 months under normal use. Full step-by-step below.

The DC33 brush bar sits behind the soleplate. Replace it when bristles are flat or the bar is cracked; if it won't spin at all, check the belt (the DC33 uses a drive belt) and clear wound hair before assuming the bar is the fault.

Compatible Brush Roll for the Dyson DC33

“OEM” is a genuine Dyson part; the rest are tested aftermarket options.

PartType
Dyson Vacuum Cleaner DC17 Animal Replacement Brushroll Roller # 10-3404-08 OEM Buy on Amazon
Envirocare Vacuum clutch Brush Roller Agitator, Belts and Belt Changing Tool to fit Dyson DC07 DC14 Aftermarket Buy on Amazon
4YourHome Brush Roll Designed to Fit Dyson DC04 DC07 DC14 DC33 Clutch Models Aftermarket Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

About the Dyson DC33

The Dyson DC33 corded upright has a powered cleaner head with a bristle brush bar driven by a belt. Worn bristles and wound hair are what most owners are replacing — a straightforward job on this older model.

Step-by-Step: Replacing the Dyson DC33 Brush Roll

1
Unplug the vacuum
Disconnect the DC33 before opening the cleaner head.
2
Remove the soleplate
Lay the head flat and release the soleplate to reach the brush bar.
3
Lift out the old bar
Ease the bar out and cut away wound hair from it and the housing.
4
Check the belt
Confirm the drive belt is intact and seated; replace it if stretched or broken.
5
Fit the new bar and test
Seat the new bar, refit the soleplate, plug in and confirm it spins.

⚠ Common mistakes on the DC33

The DC33 mistake is swapping the bar when a stretched/broken belt or wound hair is the real cause. The second is not clearing the housing channel, so the new bar runs off-balance and wears fast.

✓ OEM vs aftermarket for the DC33

A genuine Dyson bar guarantees the right bristles and fit; aftermarket bars are cheaper and fine when the listing names the DC33. Inspect and replace the belt while the head is open if it's worn.

🔁 How often to replace

The Dyson DC33 brush roll should be replaced Every 12-24 months under normal use — sooner with pets or daily heavy use. Signs it's due: Poor carpet pick-up, visible wear.

How we made this page: the steps are written for the Dyson DC33 specifically; the compatible-part list comes from our own compatibility data for this model. We are not showing prices at the moment — check the current price on Amazon.