How to Replace Dyson V7 HEPA Filter (Step-by-Step Guide)

⏱ ~10 minutes 🔧 No special tools 🔁 Every 12 months Verified October 2026
Quick answer

Replacing the Dyson V7 hepa filter is a DIY job of about 10 minutes. Replace it Every 12 months under normal use. Full step-by-step below.

Compatible HEPA Filter for the Dyson V7

“OEM” is a genuine Dyson part; the rest are tested aftermarket options.

PartType
Replacement Vacuum Rear Filter Compatible with Dyson V7 / V8 Absolute and Animal Vacuums, HEPA Post Motor Filter Fit for HH11/SV10/SV11, Compare to Part #967478-01 (purple) Aftermarket Buy on Amazon
6 Pack Vacuum Filter Replacement Kit for Dyson V8+, V8, V7 Absolute Animal Motorhead Vacuums, 3 HEPA Post Filter & 3 Pre Filter, Replaces Part # 965661-01 & 967478-01 Aftermarket Buy on Amazon
Casa Vacuums 2+1 Filter Kit for Dyson DC41, DC65, DC66 Replacement HEPA Post Filter & Pre Filter. For Animal, Multi Floor and Ball Vacuums. Compare to Part # 920769-01 & 920640-01 Aftermarket Buy on Amazon
DC41 HEPA Post-Motor Filter & Pre-Motor Filter Kit Replacement Compatible with Dyson DC41, DC65, DC66 Assembly Parts 920769-01 & 920640-01 by LifeSupplyUSA Aftermarket Buy on Amazon
Vacuum Filter Replacement Compatible with Dyson V7, V8 Animal, V8 Absolute, SV10, SV11 Vacuum Cleaner, Hepa Post Filter Set Replacement Filter Part No. 965661-01 & 967478-01 Aftermarket Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

Step-by-Step: Replacing the Dyson V7 HEPA Filter

1
Power off and unplug
Turn off your Dyson V7 and unplug it from the wall. If cordless, remove the battery pack.
2
Locate the filter compartment
Find the hepa filter housing — on most V7 units it's located near the top or rear of the cyclone assembly.
3
Remove the old filter
Twist or slide out the existing hepa filter. Avoid tapping it — this releases trapped particles into the air.
4
Inspect and clean housing
Wipe the filter housing with a dry cloth. Do not use water or cleaning products inside the vacuum.
5
Insert the new filter
Align the new hepa filter with the housing guides and press firmly until it clicks into place.
6
Test suction
Plug in (or reinsert battery) and run briefly to confirm normal suction is restored.

⚠ Common mistakes to avoid

  • Confirm the part matches your exact model number before buying — Dyson reuses parts across lines.
  • Never wash a filter unless it's marked washable, and dry it fully (24h) before refitting.
  • Don't force the part — if it resists, check alignment before applying pressure.
  • Always disconnect power (or remove the battery) before any internal work.
🔁 How often to replace

The Dyson V7 hepa filter should be replaced Every 12 months under normal use — sooner with pets or daily heavy use. Signs it's due: Reduced suction, musty odor.

How we made this page: the steps describe the standard procedure for this part type; we have not yet written a model-specific version for the Dyson V7; the compatible-part list comes from our own compatibility data for this model. We are not showing prices at the moment — check the current price on Amazon.