Replacing the Dyson DC50 HEPA Filter — Step by Step

⏱ ~10 minutes 🔧 No special tools 🔁 Every 12 months Verified October 2026
Quick answer

Replacing the Dyson DC50 hepa filter is a DIY job of about 10 minutes. Replace it Every 12 months under normal use. Full step-by-step below.

Compatible HEPA Filter for the Dyson DC50

“OEM” is a genuine Dyson part; the rest are tested aftermarket options.

PartType
Dttery 6 Pack Filters for Shark Rocket DeluxePro Zero-M Vacuum HV343AMZ, HV345, HV320, HV321, HV322, ZS350, ZS351, ZS352, Replacement Part XPMFK320 1084FTV320 Aftermarket Buy on Amazon
Fette Filter- HEPA Post-Motor Filter & Pre-Motor Filter Compatible with Dyson DC50. Compatible with Dyson Animal and Multi Floor. Compare to Part # 965081-01 & 965080-02 - Combo Pack Aftermarket Buy on Amazon
Replacement Hepa Post Filter & Washable Pre Filter Kit for Dyson DC50 Animal - Multi Floor Complete Uprights. Part # 965081-01&965080-01 Aftermarket Buy on Amazon
DC50 Filter Replacement Compatible with Dyson DC50 Animal Multi Floor Complete Vacuum, Replace Part # 965081-01 & 965080-01, Kit include 2 Pre-Motor, 2 HEPA Post-Motor Filters and 1 Cleaning Tool Aftermarket Buy on Amazon
DC50 Replacement Parts Compatible with Dyson DC50 Animal Multi Floor Complete Vacuum Cleaner, Includes 2 Pre-Motor & 2 HEPA Post-Motor Filters, Replace Part # 965081-01, 965080-01 Aftermarket Buy on Amazon
4Pcs Hepa Filters for Dyson DC50 Animal Multi Floor Vacuum Cleaner Replacements, Part No. 965081-01 Aftermarket Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

Step-by-Step: Replacing the Dyson DC50 HEPA Filter

1
Power off and unplug
Turn off your Dyson DC50 and unplug it from the wall. If cordless, remove the battery pack.
2
Locate the filter compartment
Find the hepa filter housing — on most DC50 units it's located near the top or rear of the cyclone assembly.
3
Remove the old filter
Twist or slide out the existing hepa filter. Avoid tapping it — this releases trapped particles into the air.
4
Inspect and clean housing
Wipe the filter housing with a dry cloth. Do not use water or cleaning products inside the vacuum.
5
Insert the new filter
Align the new hepa filter with the housing guides and press firmly until it clicks into place.
6
Test suction
Plug in (or reinsert battery) and run briefly to confirm normal suction is restored.

⚠ Common mistakes to avoid

  • Confirm the part matches your exact model number before buying — Dyson reuses parts across lines.
  • Never wash a filter unless it's marked washable, and dry it fully (24h) before refitting.
  • Don't force the part — if it resists, check alignment before applying pressure.
  • Always disconnect power (or remove the battery) before any internal work.
🔁 How often to replace

The Dyson DC50 hepa filter should be replaced Every 12 months under normal use — sooner with pets or daily heavy use. Signs it's due: Reduced suction, musty odor.

How we made this page: the steps describe the standard procedure for this part type; we have not yet written a model-specific version for the Dyson DC50; the compatible-part list comes from our own compatibility data for this model. We are not showing prices at the moment — check the current price on Amazon.