Quick answer

Replacing the Eureka Flash NEC222 drive belt is a DIY job of about 10 minutes. Compatible drive belts currently start at $6.99 (genuine Eureka OEM from $8.99). Replace it Every 12 months under normal use. Full step-by-step below.

Compatible Drive Belt for the Eureka Flash NEC222

Prices pulled from Amazon and verified September 2026. “OEM” is a genuine Eureka part; the rest are tested aftermarket options.

PartTypePriceRating
Eureka Upright Round Vacuum Cleaner Belt, Designed to fit 1400 Series and All Uprights Where The Belt Rides in The Center of The brushroll, 3 Belts in Pack OEM $8.99 4.75★ (0) Buy on Amazon
Replacement Style U Belts for Eureka Airspeed, Sanitaire and The Boss Power Plus Vacuum Series, Replace Parts 83797 61120A 61120B 61120C 61120D 61120F 61120G (Pack of 2) Aftermarket $6.99
$3.50/ea
4.65★ (0) Buy on Amazon
KEEPOW E0205 Vacuum Belts Replacement Fit for Eureka PowerSpeed Bagless Upright Cleaner NEU182b NEU181 NEU180 NEU188a NEU182a NEU192 NEU186 NEU188 NEU190 Series, 2 Pack Aftermarket $6.99
$3.50/ea
4.65★ (0) Buy on Amazon

As an Amazon Associate we may earn from qualifying purchases. Prices and availability change; the live price is shown on Amazon.

Step-by-Step: Replacing the Eureka Flash NEC222 Drive Belt

1
Unplug the vacuum
Always disconnect power before any internal work on your Eureka Flash NEC222.
2
Open the base plate
Remove any screws securing the base plate and set aside.
3
Remove the brush roll
Lift out the brush roll to expose the belt underneath.
4
Remove the old belt
Slide the worn belt off the motor spindle and brush roll hub.
5
Install the new belt
Loop the new belt around the motor shaft first, then stretch over the brush roll hub.
6
Reassemble and test
Replace brush roll and base plate. Test that the brush roll spins freely.

⚠ Common mistakes to avoid

  • Confirm the part matches your exact model number before buying — Eureka reuses parts across lines.
  • Never wash a filter unless it's marked washable, and dry it fully (24h) before refitting.
  • Don't force the part — if it resists, check alignment before applying pressure.
  • Always disconnect power (or remove the battery) before any internal work.
🔁 How often to replace

The Eureka Flash NEC222 drive belt should be replaced Every 12 months under normal use — sooner with pets or daily heavy use. Signs it's due: Brush roll not spinning.

How we made this page: the steps are written for the Eureka Flash NEC222 specifically; the compatible-part list is pulled from our parts database and price-checked against Amazon. Last verified September 2026.